I wanna do this lol haven't got around to doing it yet, still unsure about a few things read below in bold,
Also you can change the headlight Globes without removing the bumper, just need to remove the air intake on the driver side for easier access, - dont start the car with the intake off.. i did this once (to test globes) and the engine kind of stalls for a sec, all was good though when i put it back. on the passenger side the wiper water (washer fluid) tube just needs to be removed (1 bolt), then you can reach that globe. its much easier than taking off the whole bumper.,
on the topic of the DRL illuminating when unlocking, i made an easy to read diagram (using the info), and i have Relay 1 in place ( the DRLS function like factory) - installed myself took many hours,
Relay 2 just taps into a few wires of that Relay 1 so i dont need to remove the bumper again... just the driver door panel to tap into the Puddle light..
i will try adding RELAY 2 soon, i just need to buy some extra wire, shrink tubes, etc.
i have 1 question on the diagram though, as member "unco" said in post #5
Does the IGN fuse wire from the relay #1 go to PIN 87 and 87a on RELAY #2 ??
As one says "IGNITION" and the other says pin 30 of relay 1, which is the "IGNITION"?.. Just wanted to be sure before I attempt,
Here is the diagram I made using the info ;
http://postimg.org/image/o46d5bu7v/full/