Spacers - 5Mm Or 10Mm

[ldc]

Hi guys,

Being very long time .... and most of you don't know me. Anyways I scored a set of Rays 19" and i need 5mm only to clear the FRONT brakes.

I know spacers are never safe to use blah blah blah..but i'd like to use the Rays for a little while.

The 5mm is not hub-centric and it is thin enough to sit on your existing hub with a little left for the wheels to sit on. I was told this is ok to use and extended studs not needed.

Should i get the 5mm or get the 10mm bolt-on type? Also what and where to get them fitted?

Thanks,

- Justin

[ilv1004s]

justin can i get some more info on the wheels?

need to know the offset and width to know how close it will get to the guards with the spacers

[ldc]

Dan, they are 19 x 9, offset +47, 19 x 10, offset +30.

I guess the stock is +45 so i need 2mm to clear the fronts. I'm not sure if i need the rear fender to be rolled.

Tyres i think will be 235/35 and 275/30.

[ilv1004s]

have you tried fitting these on yet?

i dont think you will have much problem with the fronts

the rear you will need fender rolling

and if u wanna run 275 u need some big camber too

run 225 and 255 factory ISF tyre spec

[ldc]

I have not tried putting them on but people who have the same wheels all say i needed the spacers.

As for guard rolling, Sydney Guard Rolling is ok?

Are u sure 225/255 will fit 9/10 inches?

[LEX51S]

Sydney gaurd rolling is great. As for tures rims and fitment all sounds out of place.

Try them on if you have them before spending more money.

[ldc]

SGR they quoted 70 per corner. There area few guys on CL who has the same wheels. 275 vs 265 will camber be too much of a prob given i'm only lowered 1".